Process Engineer
Confirmed on the employer's own hiring board on Oct 20, 2026. First seen by Alion on Oct 19, 2026.
Process Engineer /Process Design Engineer
Process design and engineering experience of 8 to 12+ years in Oil & Gas projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.
Required Experience:
The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.
- Design Basis
- Licensor Technology Evaluation
- PFD and P&ID Preparation and or review for Urea Plant
- HMB
- Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,
- PSV Relief load estimation, PSV sizig
- Flare sizing, KOD sizing
- Pump sizing
- Compressor Calculations, Anti surge design, settle out calculations etc
- Steam generation and sizing calculations
- Design of Separators, columns, Heat Exchangers, tanks
- Hydraulic calculations, PSV sizing, Control valve sizing calculations
- Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages
- 3D Model Review
- vendor offer reviews
- Experience across conceptual design, FEED, and detailed engineering phases.
- Operation experience is not preferred.
Software/Technical Skills & Tools
- Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.
- Strong understanding of process design, sizing, and optimization techniques.
- Ability to critically review calculations and propose practical engineering solutions.
- Strong technical documentation and report-writing skills.
- Fluent in spoken and written English.
Education:
- B tech Chemical Engineering / MTech Chemical Engineering
- 75% Marks in engineering are mandatory
Job Profile
Key Responsibilities
- Perform process design review and verification across conceptual, FEED, and detailed engineering stages.
- Prepare and review process design basis, philosophies, and engineering calculations.
- Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).
- Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.
- Perform and review PSV relief load estimation and PSV sizing calculations.
- Review flare system calculations, knockout drum sizing, and associated hydraulics.
- Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.
- Review design of separators, columns, heat exchangers, tanks, and other process equipment.
- Perform hydraulic calculations and control valve sizing reviews.
- Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.
- Participate in 3D model reviews and vendor technical document reviews.
- Prepare and review technical reports, calculation notes, and design review comments.
- Ensure compliance with applicable international codes, standards, and project procedures.
- Site Visit : The candidate may be required to occasionally visit project sites to conduct audits or verification activities.
Location: Abu Dhabi, UAE